16 www.electrolux.com
Start/Pause and
Add Clothes Touchpad
This touchpad has 2 functions:
●
Start/Pause
To interrupt a program which is
running, press this touchpad to pause
the machine, the Start/Pause pilot light
flashes.
After you have selected the desired
program and options, press this
touchpad to start the machine. The
Start/Pause pilot light will stop flashing
and remain lit until the water level is
above the bottom edge of the door
then pilot light goes OFF. If you have
selected a “Delay Start” option, the
countdown will begin and will be
shown in the display.
To restart the program from the point
at which it was interrupted, press this
touchpad again, the Start/Pause pilot
light will stop flashing.
●
Add Clothes
While running a program, you may add
clothes by:
Pressing the “Start/Pause” touchpad
to pause the program.
You can only add clothes if
“Start/Pause” pilot light is lit.
-
Wait for the machine to come to a
complete stop before opening the
door.
-
Resume the program by pressing
“Start/Pause” touchpad again.
-
Add clothing and close the door.
-
BEFORE FIRST USE
4.
Ensure that the electrical and water
connections comply with the
installation instructions.
Put 2 litres of water in the detergent
compartment for washing phase. This
activates the drain system.
1.
2.
3.
Select a Cottons cycle at 90 °C,
without any laundry in the machine, to
remove any manufacturing residue
from the drum and tub then start the
machine.
3.7
During installation or before first use you
may observe some water in the machine.
This is a residual water left in the
machine after a full functional test in the
factory to ensure the machine is
delivered to customers in perfect working
order and is no cause for concern.
You cannot open the door if
the water inside the machine
drum are hot, the door remains
locked for your safety.
Although the LED light still
remain lit.