The related indicator flashes.
2. Change the options (if you wish to
change the Time Manager option,
you must cancel the running
programme and make your selection
again).
3. Press the Start/Pause button again.
The programme continues.
10.8 Cancelling a running
programme
1. Turn the programme knob to On/Off
position to cancel the programme.
The appliance is deactivated.
2. Now, you can set a new washing
programme and the available
options.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment; if
not, fill the detergent again.
10.9 Opening the door
While a programme is running or during
the Delay Start, the appliance door is
locked. The indicator is on.
CAUTION!
If the temperature and level
of the water in the drum are
too high and the drum still
rotates, you cannot open the
door.
To open the door during the first minutes
of the cycle or when the Delay Start
operates:
1. Press the Start/Pause button to
pause the appliance.
2. Wait until the indicator goes off.
3. You can open the door.
4. Close the door and press the Start/
Pause button again.
The programme (or the Delay Start)
continues.
10.10 At the end of the
programme
• The appliance stops automatically.
Some acoustic signals sound (if they
are activated).
• In the display the value
come
on. The Start/Pause indicator goes
off.
• When the door lock indicator goes
off, you can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty. Close the water tap.
• Turn the programme knob to On/Off
position to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door lock indicator is on. The
door stays locked.
• You must drain the water to open the
door.
To drain the water:
1. Turn the programme knob to On/Off
position an then select a spinning or
draining programme.
2. Press the Start/Pause button. If
necessary, decrease the spin speed.
The appliance spins and drains or only
drains.
3. When the programme is completed
and the indicator goes off, you
can open the door.
4. Turn the programme knob to On/Off
position to deactivate the appliance.
10.11 Stand-by
Once the programme has finished, after
a few minutes the energy saving system
will be enabled.
The brightness of the display is reduced.
By pressing any button the appliance will
come out of the energy saving status.
www.electrolux.com
18
Summary of Contents for EWX 147410 W
Page 1: ...EWX147410W EN Washer Dryer User Manual ...
Page 38: ...www electrolux com 38 ...
Page 39: ...ENGLISH 39 ...