3.
4.
45°
20°
14.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor
and let water flow out of the hoses.
4. Set the Drain programme and let it
operate until the end of the cycle.
5. Turn the programme knob to On/Off
to disconnect the appliance from the
power supply.
6. Screw the water inlet hose back on
and re-fit the emergency emptying
hose after having put the cap on
again.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
14.9 Emergency emptying out
If the appliance does not drain the water,
proceed as follows:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. If necessary, wait until the water has
cooled down.
4. Place a bowl on the floor and put the
end of the emergency emptying hose
into the bowl. Remove its cap.
The water should drain by gravity into the
bowl.
5. When the bowl is full, put the cap
back on the emergency hose.
6. Empty the bowl. Repeat the
procedure until water stops flowing
out.
7. Clean the pump if necessary as
previously described.
8. Replace the emergency emptying
hose in its seat after having plugged
it.
9. Screw the water inlet hose back on.
15. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
15.1 Introduction
The appliance does not start or it stops
during operation.
www.electrolux.com
26
Summary of Contents for EWX 147410 W
Page 1: ...EWX147410W EN Washer Dryer User Manual ...
Page 38: ...www electrolux com 38 ...
Page 39: ...ENGLISH 39 ...