13
Assembly of the burner caps
Make sure that all of the surface burner caps and surface
burner grates are installed correctly and at the correct loca-
tions.
1.
Remove all packing material from the cooktop area.
2.
Make sure burner caps are properly placed on the
surface burners.
3.
Unpack the burner grates and position them on the
cooktop.
4.
Discard all packing material.
On round-style burners, the burner cap lip (
fit snug into the center of the burner head and rest level.
Refer to
for correct and incorrect burner cap place-
ment.
Figure 2:
Proper burner cap placement
Once in place, you may check the fit by gently sliding the
burner cap from side to side (
) to be sure it is
centered and firmly seated. When the burner cap lip makes
contact inside the center of the burner head you will be able
to hear the burner cap click.
Figure 3:
Gently move cap for proper placement
Figure 1:
Burner caps and burner heads
•
Do not allow spills, food, cleaning agents, or any
other material to enter the gas orifice holder opening.
•
Always keep the burner caps and burner heads in
place whenever the surface burners are in use.
•
Never place flammable items on the cooktop.
Burner cap lip
Burner cap
Burner head
Burner cap
Burner head
CAUTION
Please note that the burner cap should not move off the
center of the burner head when sliding from side to side.
•
Check and be sure that all oval-style burner caps
(some models) are correctly in place on oval burner
heads.
•
Do not use the surface burners without the burner
caps properly installed. Improperly seated burner
caps may prevent burners from lighting or cause
uneven flame and heating.
•
Missing pieces or improper installation may lead to
spills, burns, or damage to your range and cookware.
•
Never place flammable items on the cooktop.
IMPORTANT
BEFORE SETTING SURFACE CONTROLS
Summary of Contents for Frigidaire FGGF3036TDD
Page 43: ......