Electrolux GK58TSICN, User Manual

To remove the dirt:

1. –

Remove immediately:

 melted plas-

tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance. Use a special scraper
for the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .

–

Remove after the appliance is
sufficiently cool:

 limescale rings ,

water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.

2. Clean the appliance with a moist cloth

and some detergent.

3. At the end 

rub the appliance dry

with a clean cloth.

WHAT TO DO IF…

Problem

Possible cause and remedy

You cannot activate the appli-
ance or operate it.

• Activate the appliance again and set the heat setting in 10 sec-

onds.

• You touched 2 or more sensor fields at the same time. Only

touch one sensor field.

• The Child Safety Device or the Lock or Stop+Go operates. See

the chapter Operating instructions.

• There is water or fat stains on the control panel. Clean the con-

trol panel.

A Sound operates and the ap-
pliance deactivates.
A sound operates when the ap-
pliance is deactivated.

You put something on one or more sensor fields. Remove the ob-
ject from the sensor fields.

The appliance deactivates.

You put something on the 

 . Remove the object from the sen-

sor field.

The residual heat indicator
does not comes on.

The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen-
tre.

The Automatic Heat Up func-
tion does not operate.

• There is still residual heat on the cooking zone. Let the cooking

zone become sufficiently cool.

• The highest heat setting is set. The highest heat setting has the

same power as the Automatic Heat Up function.

The heat setting changes be-
tween two levels.

The Power management is activated. See the section Power
management.

The sensor fields become hot.

The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.

There is no signal when you
touch the panel sensor fields.

The signals are deactivated. Activate the signals (see OffSound
Control).

 comes on

The Automatic Switch Off operates. Deactivate the appliance and
activate it again.

 comes on

• No cookware on the cooking zone. Put cookware on the cook-

ing zone.

• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the

cooking zone. Move cookware to a smaller cooking zone.

electrolux 

11