3. INSTALLATION
WARNING!
Refer to Safety chapters.
3.1 Before the installation
Before you install the hob, write down the
information below from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
3.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
During installation in combustible matter,
NIN SEV 1000 and fire protection
guidelines and regulations of the
Association of Cantonal Fire Insurance
shall be strictly adhered to.
3.3 Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable,
use the cable type: H05V2V2-F which
withstands a temperature of 90 °C or
higher. Contact an Authorised Service
Centre. The connection cable may
only be replaced by a qualified
electrician.
3.4 Electrical connection
Install the hob with a socket supply line.
If there is no socket supply line, the fixed
home electrical system must include an
isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000).
1
2
3
1
2
3
1
2
3
1
2
3
3.5 Attaching the seal -
Integrated installation
1. Clean the rabbets in the worktop.
2. Cut the supplied 3x10mm seal stripe
into 4 stripes. The stripes must have
the same length as the rabbets.
3. Cut the ends of the stripes at an
angle of 45°. They should fit in the
corners of the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not stretch the stripes. Do not bond
the ends of the stripes one over the
other.
After you assemble the hob, seal the
remaining gap between the glass
ceramic and the worktop with silicone.
Make sure the silicone does not get
under the glass ceramic.
3.6 Attaching the seal - On-top
installation
1. Clean the worktop around the cut out
area.
2. Attach the supplied 2x6mm seal
stripe to the lower edge of the hob,
along the outer edge of the glass
ceramic. Do not stretch it. Make sure
that the ends of the seal stripe are
located in the middle of one side of
the hob.
ENGLISH
7