Electrolux ICF100E, Instructions For Use Manual

4

POSITION

Place the freezer horizontally on a firm

surface, resting on all four plastic feet.

Use a wooden block or similar object

to compensate for any bumps/holes in

the surface.
The room should be dry and

adequately ventilated.
If the room temperature exceeds

32°C, or falls below freezing point, the

freezer will not function as it should.
Do not place the freezer close to

sources of heat, radiators, chimneys,

etc., and do not place the freezer in

direct sunlight.
If the freezer has been handled

standing on end it should be allowed to

stand in normal position for about 12

hours before switching it on.
Please ensure that when the appliance

is installed it is easily accessible for the

engineer in the event of a breakdown.

ELECTRICAL REQUIREMENTS.

Before switching on, make sure that the

voltage of your electricity supply is the

same as that indicated on the rating plate,

located inside the lid.

For your convenience, this appliance comes

complete with either a moulded-on or re-

wireable 13 amp (BS1363) plug, protected

by a 13 amp ASTA approved (BS1362) fuse.
In the event of having to change the fuse

in the plug supplied, a replacement 13

amp ASTA approved (BS1362) fuse must

be used.
In the case of a moulded-on plug, the fuse

cover MUST be refitted after changing

fuse. If the fuse cover is lost or damaged

the plug MUST NOT be used until a

replacement is obtained.

Warning:
This appliance must be earthed.