Problem
Possible cause
Solution
The compressor operates
continually.
Temperature is set incor-
rectly.
Refer to "Operation" chapter.
Many food products were
put in at the same time.
Wait some hours and then
check the temperature again.
The room temperature is
too high.
Refer to climate class chart
on the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool
to room temperature before
storing.
The door is not closed
correctly.
Refer to "Closing the door".
The ActionFreeze function
is switched on.
Refer to "ActionFreeze func-
tion".
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
Water flows inside the re-
frigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Food products prevent
that water flows into the
water collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The ActionFreeze or
ShoppingMode function is
switched on.
Switch off ActionFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "Action-
Freeze or ShoppingMode
function".
DEMO appears on the dis-
play.
The appliance is in dem-
onstration mode.
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
ENGLISH
73
Summary of Contents for IK2550BNR
Page 79: ...ENGLISH 79 ...
