• To remove the scraper:
- Hold the scraper hub with one hand and, while exerting
pressure between the 2 parts, turn the handle anti-clockwise
( ) (seen from above) to release them.
Note:
The lid centre hole can be closed off with the stopper supplied
with the machine when the scraper is not being used.
3.
4
USING
• Fitting the scraper onto the lid:
- Fit the scraper
P
underneath in the lid centre hole.
- Position the handle
A
lug in the scraper housing and lower it
to the stop.
- Hold the scraper hub with one hand and, while exerting pressure
between the 2 parts, turn the handle clockwise ( ) (seen
from above) to lock them.
• Raise the bowl
E
vertically by its handle
D
. The rotor
R
is released
automatically. The rotor can also be removed separately.
• To fi t the scraper onto the lid see §3.4.
• To equip the food processor, install:
- The bowl
E
on the centre axis, making sure the bowl locking
stud is properly positioned in its housing
M
.
- The rotor
R
on the drive shaft
L
as far as the stop. Next introduce
the products to be worked (never before installing the rotor).
- Pull down the lid
B
(fi tted with its seal N) onto the bowl
E
and
lock it with the handle
C
.
The appliance is ready for use.
3.
3
STARTING UP
• Before starting any work, always check the cleanliness of the
rotor
R
, the bowl
E
, the lid
B
and its seal
N
, the scraper
P
and
its handle
A
and the drive shaft
L
.
• To remove the lid:
- Release the lid using the handle
C
.
- Open the lid as far as the rear stop
- Withdraw the locking pin
- Withdraw the lid
• Use the notch at the back of the lid to withdraw the seal
N
.
• For re-assembly, proceed in the reverse order, making sure
that the locking pin is fully pushed in when the lid is in the fully
open position.
3.
3A
3.
3B
3.
3C
3.
4
• Always start at slow speed before changing to a faster
speed.
• Use the speed under sustained pressure to start or fi nish work
requiring a certain amount of surveillance or a precise degree
of fi nishing.
• While working, turn the handle clockwise ( ) (seen from
above) to clean the bowl and lid walls and to give consistency
to the product. To loosen doughy products from the scraper,
turn the handle sharply clockwise ( ) and then anti-clockwise
( ).
Never introduce the hand or hard bodies into the bowl when
the machine is on.
Note:
- Liquid products or ingredients may be introduced by the handle
chute.
- The slope in the knives ensures a fast, consistent mix.
K45-55-70 GB 01 08
4