Problems with Wi-Fi signal
Possible cause
Remedy
New router installed or router configuration
changed.
To configure oven and mobile device again, re‐
fer to "Before first use" chapter, Wireless con‐
nection.
The wireless network signal is weak.
Move router as close to the oven as possible.
The wireless signal is disrupted by a micro‐
wave appliance placed near the oven.
Turn off the microwave appliance.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
Action
F240, F439 - the touch fields on the display do not
work properly.
Clean the surface of the display. Make
sure there is no dirt on the touch fields.
F601 - there is a problem with Wi-Fi signal.
Check your network connection. Refer to
"Before first use" chapter, Wireless con‐
nection.
F604 - the first connection to Wi-Fi failed.
Turn the oven off and on and try again.
Refer to "Before first use" chapter, Wire‐
less connection.
F908 - the oven system cannot connect with the
control panel.
Turn the oven off and on.
In this section, you will find the list of the problems that have to be handled by a qualified
technician.
Code and description
Action
F131 - the temperature of magnetron sensor is too
high.
Turn the oven off and wait until it cools
down. Turn the oven on again.
36/48
TROUBLESHOOTING
Summary of Contents for KVLAE00WT
Page 38: ...13 TECHNICAL DATA 13 1 Technical data Voltage 220 240 V Frequency 50 Hz 38 48 ...
Page 46: ...46 48 ...
Page 47: ...47 48 ...