Electrolux LIC744I User Manual Download

Page: 8 / 168

non-electrical energy, the negative

pressure of the room must not exceed 4

Pa (4 x 10

bar). This manual must be

stored for future consultation at any time.

If sold, transferred or moved, it must

remain with the device.

Caution!

Failure to install screws and

fasteners in accordance with these

instructions may result in electrical

hazards.

Both electric and mechanical

installation must be carried out by

specialised personnel.

The electrical appliance is designed to be

built into a work top with a thickness of 2-

6 cm in the case of TOP installation; 2.5-

6 cm in the case of FLUSH installation.

The minimum distance between the hob

and the wall must be at least 5 cm in

front, at least 4 cm on the sides and at

least 50 cm from overhead wall units.

NB = The recommended distances are

given as examples: when planning the

spaces, the indications of the kitchen

manufacturer must be observed.

Electrical connection:

Disconnect the device from the electric

power supply.

Installation must be

carried out by professionally qualified

personnel with knowledge of the

regulations in force for installation and

safety.

The manufacturer denies all

liability to persons, animals or property if

the guidelines provided in this chapter

are not followed.

The power cable

must be long enough to allow the hob to

be removed from the worktop.

Make

sure that the voltage on the serial

number data plate on the bottom of the

device corresponds to that of the

domestic environment where it will be

installed.

Do not use extension leads.

The earth power cable must be 2cm

longer than the other cables.

If the

electrical appliance is not supplied with a

power cable, use one with a minimum

conductor diameter of 2.5 mm2 for power

up to 7200 Watt; for higher power levels,

the diameter must be 4 mm2.

The

temperature must not reach 50°C above

room temperature anywhere along the

cable.

The appliance is intended for

permanent connection to the power

supply.

Please note!

Before reconnecting the

circuit to the mains power supply, make

sure that it is working correctly, always

check that the power cable is correctly

installed.

Please note!

The

interconnection cable must be replaced

by the authorised technical support

service or by a person with similar

qualifications.

Note:

to connect the appliance using the

optional single phase connection the

existing cable must be removed and

replaced with another type (not supplied)

having the following specifications:

single phase connection:H05V2V2-F 3G4

cable

Note :

the product is equipped with a

Power Limitator function, which allows a

maximum power limit to be set

The limit must be set at the time of the

product's connection to the electrical

network or when the electrical network

itself is reconnected (within the following

2 minutes). For the Power Limitation

setting sequence, see the Operation

section of this manual.

This device is marked in compliance with the European
Directive 2012/19/EC - UK SI 2013 No3113, Waste Electrical
and Electronic Equipment (WEEE). By ensuring that this
device is disposed of correctly, the user will help prevent
potential negative impacts on the environment and human
health.

The

symbol on the device or documentation provided

indicates that this device must not be treated as domestic