Electrolux LUC6NE25W, User Manual

Problem

Possible cause

Solution

Food products placed in

the appliance were too

warm.

Allow food products to cool

to room temperature be‐

fore storing.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The FastFreeze function is

switched on.

Refer to "FastFreeze func‐

tion" section.

The compressor does not

start immediately after

pressing the "FastFreeze",

or after changing the tem‐

perature.

The compressor starts af‐

ter a period of time.

This is normal, no error

has occurred.

Door is misaligned or inter‐

feres with ventilation grill.

The appliance is not level‐

led.

Refer to installation instruc‐

tions.

Door does not open easily. You attempted to re-open

the door immediately after

closing.

Wait at least 30 seconds

between closing and re-

opening of the door.

Side panels of the appli‐

ance are warm.

This is a normal state

caused by operation of the

heat exchanger.

The lamp does not work.

The lamp is in stand-by

mode.

Close and open the door.

The lamp is defective.

Contact the nearest Au‐

thorized Service Centre.

There is too much frost

and ice.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The gasket is deformed or

dirty.

Refer to "Closing the door"

section.

Food products are not

wrapped properly.

Wrap the food products

better.

Temperature is set incor‐

rectly.

Refer to "Control Panel"

chapter.

Appliance is fully loaded

and is set to the lowest

temperature.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Temperature set in the ap‐

pliance is too low and the

ambient temperature is too

high.

Set a higher temperature.

Refer to "Control Panel"

chapter.

ENGLISH

15