6
The combination floor nozzle can
be set for hard floors or carpets.
Press the foot operated toggle
lever on the floor nozzle to select the
desired setting. When the floor nozzle
is set for hard floors, the bristles
will extend beyond the base of the
floor nozzle. When the floor nozzle
is set for carpets, the bristles will
be retracted.
Maintenance
EMPTYING THE DUST CONTAINER
Note: Before removing the dust
container, switch off the appliance
and disconnect the flexible hose.
•
Remove the dust cup by pushing the
open buttons on the dust container
handle. Remove the content of the
dust cup by pushing the opening
button.The dust container is a
detachable unit. Hold the base of the
dust cup with one hand and open
the dust container by pushing the
opening button with the other hand.
•
Empty the dust container.
•
To close the dust container,ensure
that hinge is securely fasten before
you locked the cover.
•
Replace the dust container, always
operate the appliance with
the dust container properly installed.
REPLACING AND CLEANING
THE MOTOR FILTER AND
EXHAUST FILTER
•
Filter for air-inlet should be cleaned
at least twice a year or when it
becomes visible solid.
•
Always operate the cleaner with
filters.
•
To avoid reduced suction or
motor damage.
•
Remove the dust container as
described in the previous section.
•
There are two pre-motor filters
in this vacuum cleaner, a spongy
grey protection filter, and the
framed filter.
•
Remove the filter frame from the
container by pulling on the release
tab on the top right side of the filter
frame. Remove the grey protection
filter by simply pulling it loose from
the container.
•
Tap the filter face down on a flat
surface covered with a sheet
of paper. This will dislodge
excessive residue from the filter.
Dispose of the cover sheet with the
dust residue. Gently beat the grey
protection filter in an open air space
to properly dislodge any dust.