10
electrolux
installation manual
low voltage
cable
contact pins
inlet valve
low voltage
connetion terminals
low voltage cable
with stripped ends
low voltage
cable
inlet vavles conneted
in series
inlet valve1
inlet valve 2
inlet valve 3
low voltage circuit diagram
It is recommended that the low-voltage cable be installed in a conduit
pipe, and this is absolutely necessary when cables are to be hidden in
cast concrete. If the cable becomes defective, it is also much easier
to change it afterwards. In these installations, only certified electrical
components may be used.
The power unit is connected to an electrical outlet. If there is no outlet
nearby, an electrician will carry out installation.
All the high-voltage connections are under the turbine cover. Only an
electrician is allowed to open the cover.
To power on the central vacuum system, a 24V low-voltage cable is
routed to each inlet valve. Parallel connection is made according to the
figure below.
Electrical Connection-
Low-Voltage Cable
