Electrolux RKG600005W, User Manual

5.1 Initial Cleaning

Remove all accessories and removable

shelf supports from the oven.
Refer to "Care and cleaning" chapter.

Clean the oven and the accessories

before the first use.

Put the accessories and the removable

shelf supports back to their initial

position.

5.2 Preheating

Preheat the empty appliance to burn off

the remaining grease.

1. Set the maximum temperature.

2. Let the appliance operate for

approximately 20 minutes.

3. Set the function   and the maximum

temperature. The maximum

temperature for this function is

210 °C.

4. Let the appliance operate for 15

minutes.

WARNING!

Accessories can become

hotter than usual.

The appliance can emit an odour and

smoke. This is normal. Make sure that

the airflow is sufficient.
Let the oven cool down. Dampen a soft

cloth with warm water and a little mild

washing-up liquid and use this to clean

the oven cavity.

6. HOB - DAILY USE

WARNING!

Refer to Safety chapters.

6.1 Ignition of the hob burner

Always light the burner

before you put on the

cookware.

WARNING!

Be very careful when you

use open fire in the kitchen

environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

1. Turn the knob for the hob

counterclockwise to the maximum
gas flow position   and push it

down to light the burner.

2. Keep the knob for the hob pushed for

equal or less than 10 seconds to let

the thermocouple warm up. If not, the

gas supply is interrupted.

3. Adjust the flame after it is regular.

WARNING!

Do not keep the knob

pushed for more than 15

seconds. If the burner does

not light after 15 seconds,

release the knob, turn it into

the off position and try to

light the burner again after

minimum 1 minute.

If after some tries the burner

does not light, check if the

crown and its cap are in the

correct position.

In the absence of electricity

you can ignite the burner

without an electrical device.

In this case approach the

burner with a flame, push

the relevant knob down and

turn it to maximum position.

Keep the knob pushed for

equal or less than 10

seconds to let the

thermocouple warm up.

If the burner accidentally

goes out, turn the knob to

the off position and try to

light the burner again after

minimum 1 minute.

www.electrolux.com

16