Electrolux T3290, Operating Manual

Error codes

16

Error codes

The dryer has automatic error indication.

Error indication is displayed as a flashing code.

Please refer to the Programming manual for Selecta Control for an explanation of error 
codes.

A service technician must be contacted should an error be displayed.

The user can, however, try to correct some error codes himself.

Error code E05 or E06

When error code E05 or E06 is displayed this can be due to the motor being too hot.

Stop the dryer and wait for 5 minutes. Start again and choose a program. If this does not 
help and the error code reappears a service technician must be contacted.

Error code E12

When the error code is displayed this can be due to the user having overfilled the dryer. 

Remove some of the clothes, close the door, and press the start button. If this does not 
help and the error code reappears a service technician must be contacted.

Error code E14. OPL laundries only

When resetting gas error 

E14

 the dryer must be in operation on a program with heat, 

and the heating indicator must be on.
The dryer must only be reset 3 times.
If the dryer, however, has to be reset more than 3 times it must be put out of order and a 
service technician must be called.

Error code E15

When the error code is displayed this can be due to the user having overfilled the dryer.

Remove some of the clothes, close the door, and press the start button. If this does not 
help and the error code reappears a service technician must be contacted.

Error code E16

The error code is displayed if the user presses the start button while the vacuum switch is 
already closed.

Resetting by opening / closing the door and pressing start button.