46
Unscrew the screws fixing the lower door holder
(2 pieces) and remove it according to figure.
Fix lower door holder on the other side.
Fit the door to the lower door holding pin.
To fit top door holder remove plastic coverings of
door holder holes carefully (e. g. with a knife) and
put them on the other side.
Fix top door holder with 2 screws in the place set
free being careful that the edge of the door is
parallel with the side of cupboard.
Put the covering of top door holder back.
Put over the handle and the plastic nails on the
other side.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Change of door opening direction
Should the setting-up or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Following operations are to be done on the basis of
figures and explanations:
Break the circuit of the appliance.
Take the covering of top door holder off, unscrew
the screws fixing the top door holder (2 pieces) and
take it off according to figure.
Take the door off.
GB
SV/E/6. (05.)
