44
Timer
Changing the
Message Display
Language
Error Messages
Normal. Timer: Auto
Select timer?
English
Select language?
Error: 7
Check
the bumper
See manual
Timer
It is possible to set the time duration for
Normal or Quick vacuuming.
1. Select the desired vacuum programme, or
press
twice til “Select timer?” is shown.
Confirm by pressing
.
2. Set the desired time setting by pressing
and then confirm by pressing
.
When “Auto” is chosed Trilobite will
calculate its own vacuuming time.
When “On” is chosed, use
to set
desired time, confirm by pressing
.
When “Off” is chosed Trilobite will clean
until charging is needed.
For normal vacuuming programme, this is
the vacuuming time after wall mapping.
3. Press
to commence vacuuming.
Language
Trilobite is able to present the informa-
tion on the display in a number of diffe-
rent languages.
1. To change the display language, switch
on Trilobite and press
.
2. The display will ask whether you want to
change the programme. Ignore this and
press .
3. The display will ask whether you want to
change the time setting. Ignore this and
press .
4. The display will ask whether you want to
change the language. Press
.
5. Press
to select the desired language
and confirm by pressing
.
Trilobite will now show display messages
in the selected language.
Status Messages
When you select a function, a status
message is shown on the display for about
seven seconds. After this, the name of the
function is shown again. It is of course
possible to change or confirm a displayed
function even while the status message is
shown.
Error Messages
The only faults that you can rectify your-
self are the ones listed below. In the event
of other error messages, recharge and
restart your Trilobite. If it still does not
start, contact our Customer Service, see
page 48.
The errors you can correct yourself are
presented below:
5. Check roller.
Is something stuck?
Is it incorrectly attached?
6. Check casters.
Is something stuck?
7. Check bumper.
Verify its spring action. Is something
stuck preventing it from moving?
12. Trilobite is stuck.
Move it and switch it on again. Also see
Normal Vacuuming on page 36.
15. Check dust cassette.
In most cases, the filter unit has probably
not been set or it is incorrectly set.
16. Check charger.
Is the charger connected to the mains?
Are the terminals on the charger and
Trilobite properly connected to each
other?
21. Moisture on the circuit board.
Let the machine dry out for 12 hours.
Then try restarting it.
