What to do if ...
Troubleshooting by yourself
Problem
1)
Possible cause
Remedy
Dryer does
not work.
Dryer not connected to mains supply.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Loading door opened.
Close loading door
The START PAUSE button not pressed.
Press the START PAUSE button.
Unsatisfactory
drying results.
Incorrect programme set.
Set suitable programme.
2)
Fluff filters clogged.
Clean fluff filters.
3)
Heat exchanger clogged.
Clean heat exchanger.
3)
Max. loading exceeded.
Respect max. loading volume.
Covered ventilation grill.
Uncover ventilation grill in base area.
Residue inside the drum.
Clean the drum inside.
High water hardness.
Set suitable water hardness
4)
.
Loading door
does not close
Filters not locked in place.
Install fine filter and/or snap course filter
into place.
Err
(
Error
) on
the LCD.
5)
Attempt to change parameters after start
of the programme.
Turn the dryer off and on. Set requested
parameters.
No drum light
Programme selector in OFF position.
Turn it to DRUM LIGHT (if available) or to
any programme.
Defective light bulb.
Replace light bulb (see next section).
Abnormally
elapsing time
on the LCD
5)
Time to end is calculated on the basis of:
type, volume and dampness of laundry.
Automatic process; this is not a machine
fault.
Programme
inactive
Full water reservoir.
Empty water reservoir
3)
, press START
PAUSE button.
Drying cycle
to short
Small laundry volume./Too dry laundry for
selected programme.
Select time programme or higher drying
level (e.g. EXTRA DRY).
Drying cycle
to long
6)
Fluff filters clogged.
Clean fluff filters.
To high loading volume.
Respect max. loading volume.
Laundry insufficiently spun.
Spun adequately the laundry.
Particularly high room temperature - no
machine fault.
Lower the room temperature if possible.
1) In case of error message on the LCD (e.g.
E51
- only dryers with the LCD): Switch the dryer off and
on. Set programme. Press the START PAUSE button. Does not work? - inform local service and quote
the error code.
2) follow program recommendation - see
Programme overview
chapter
3) see
Care and cleaning
chapter
4) see
Machine settings
chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see
Drying cycle complete
section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially
for dryers. The special bulb can be obtained from
your local service centre.
Important!
When the appliance is switched on,
the interior lighting switches itself off after 4
minutes when the door is open.
56
electrolux
Summary of Contents for TW SL EEV
Page 59: ...electrolux 59 ...
