(Signal) function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the Auto/Off button for 2 seconds
to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Important!
After each drying cycle:
• clean the filter
• drain the water container
(See chapter
CARE AND CLEANING
.)
HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry be-
comes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the bot-
tom of the appliance clear.
• Use the load volumes which are specified
in the programmes chapter.
• Make sure that is good airflow in the ap-
pliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view
on the control panel.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe
1200 g
quilt cover
700 g
man’s work shirt
600 g
man’s pyjamas
500 g
sheet
500 g
tablecloth
250 g
man’s shirt
200 g
night dress
200 g
pillow case
200 g
towelling towel
200 g
blouse
100 g
ladies’ briefs
100 g
men’s underpants
100 g
napkin
100 g
tea cloth
100 g
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an effect
on the water conductivity and the operation
of the conductivity sensor in the appliance.
If you know the value of the water conduc-
tivity you can adjust the sensor to dry with
the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time 2 buttons (see
the illustration). Hold down until one of
the symbols come into view on the dis-
play:
–
low conductivity <300
μ
S/
cm
–
moderate conductivity
300-600
μ
S/cm
–
high conductivity >600
μ
S/
cm
3. Push the button again and again until
you set necessary level (see the illustra-
tion).
36
electrolux
