WARNING!
Do not start the machine until it has been in
position for 24 hours. If for some reason the
tumble dryer needs to be laid down for transport
or service, it must be laid on its left side viewed
from the front.
Positioning the tumble dryer
The tumble dryer can be free-standing or in a
stack. Remember that the tumble dryer produces
heat and should therefore not be located in a room
that is too small. If the room is very small, drying
will take longer due to the limited quantity of air.
WARNING!
• Any electrical installation must be carried out
by qualified professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
• The tumble dryer's plinth ventilation must not
be blocked by a rug or the like.
NOTE!
To improve ventilation, leave the door to the
room where the tumble dryer is located open.
Freestanding
The tumble dryer can be positioned beside the
washing machine. An air gap of at least 5 mm
must be left between the washing machine and
the tumble dryer.
Stacking
The tumble dryer can be placed on top of a
Electrolux washing machine. Use the two foot
cups found in the document bag included with the
machine and the two tip guards attached to the
bottom left corner of the back of the machine.
How to assemble the stack:
1. Undo the anti-tilt device.
2. Undo the two screws indicated on the back of
the washing machine.
3. Secure the anti-tilt device using the screws as
shown in the picture.
21
Installation