Problem
1)
Possible cause
Remedy
The loading
door does not
closed
The filter not locked in the posi-
tion.
Put the filter in the correct posi-
tion.
The laundry is locked between
the door and the seal.
Put the load correctly in the drum.
Err
(Error) on
the display.
You try to change the programme
or the option after the start of the
cycle.
Turn the tumble dryer off and on.
Make the new selection.
The option you try to activate is
not applicable with the selected
programme.
Turn the tumble dryer off and on.
Make the new selection.
No drum light
Defective drum lamp.
Contact the service centre to re-
place the drum lamp.
Abnormally
elapsing time
on the display.
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
The automatic procedure — this
is not the appliance malfunction.
Programme in-
active.
The water container is full.
Drain the water container, push
the Start/Pause button.
3)
Drying cycle too
short.
Too small laundry volume.
Do the selection of time pro-
gramme. The time value must be
related to the load. To dry 1 item
or small quantities of the laundry
we recommend to use short
times.
The laundry is too dry.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry (Extratrocken))
Drying cycle too
long
6)
The filter is clogged.
Clean the filter.
Too high volume of the load.
Obey the maximum load volume.
The laundry not spun sufficiently.
Spin correctly the laundry.
Very high room temperature - this
is not the appliance malfunction.
If possible, lower the room tem-
perature.
1)
If there is an error message on the display (e.g.
E51
): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not operate? -
contact the service centre and give the error code.
2)
Follow the programme description — see PROGRAMME TABLE
3)
See chapter CARE AND CLEANING
4)
Only dryers with the Dry Plus () option
5)
See HINTS AND TIPS chapter
6)
Note: After maximum 5 hours the drying cycle ends automatically.
www.electrolux.com
22
