13
Electrolux 818 21 42-01/1
Door Reversal
1. Close the appliance and disconnect the appliance
from the electricity socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Remove and
reposition it on the opposite side.
3. Support the appliance on a wooden block when it
is laid down. This will make it easier to grip under
the appliance when returning to an upright position.
4. On the upper part of the appliance. Remove the
hinge pin and replace on the other side.
5. On the lower part of the appliance.
a. Unscrew the hinge.
b. Remove the door-closing fittings from the hinge
and put the hinge pin on the other side. Then attach
the supplied door-closing fitting.
6. a. Remove the door-closing fitting from the
bottom of the door.
b. Remove the plastic plug from the corresponding
hole on the other side. Use a screwdriver to lever the
plug loose. Then secure the supplied door-closing
fitting.
c. Secure the lower hinge.
7. Raise the appliance and replace the ventilation
grille.
8. To transfer the handle.
Unscrew the screws. Push the blanking plugs into
the holes on the opposite side of the door. Fit the
handle onto the opposite side by turning it one half
circle. Press the supplied plastic plugs into the holes
to which the handle was previously fitted.
9. Put the appliance in position. Check that the
appliance is level. See the section "Positioning the
appliance".
1
2
3
4
5 a
5 b
a
b
c
6
