4
Important Safety Instructions
'
*5((1 <(//2:
$03)86(
%52:1
&25'&/$03
%/8(
$03
Electrical connections
Any electrical work required to install this appliance should
be carried out by a qualified electrician or competent person.
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this
safety measure not be observed.
If the plug that is fitted to your appliance is not suitable for
your socket outlet, it must be cut off and the appropriate
plug fitted.
Remove the fuse from the cut off plug. The cut off plug should
then be disposed of to prevent the hazard of shocks in case
it should be plugged into a 13amp socket in another part of
your home.
IMPORTANT
The wires in the mains lead are coloured in accordance with
the following code:
Green and Yellow
- Earth
Blue
- Neutral
Brown
- Live
If you fit your own plug, the colours of the wires in the mains
lead of your appliance may not correspond with the markings
identifying the terminals in your plug, proceed as follows:
For replacement, use a 13amp BSI362 fuse. Only ASTA or
BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost.
The cover/carrier is indicated by the coloured insert at the
base of the plug.
A replacement cover/carrier must be obtained from your local
Service Force Centre.
This appliance complies with the E.E.C. Directive No.
87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following E.E.C.
Directives:
-
73/23 EEC of 19.2.73
(Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent modifications.
Please ensure that when the appliance is installed it
is easily accessible for the engineer in the event of a
breakdown.
Connect the Green and Yellow (earth) wire to the terminal in
the plug which is marked with the letter <<E>> or the earth
symbol
or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug
which is marked with the letter ÇNÈ or coloured black.
Connect the brown (live) wire to the terminal in the plug
which is marked with the letter ÇLÈ or coloured red.
The plug moulded onto the lead incorporates a fuse.
