2
4
Using your Vac & Steam
Fig 5
Fig 6
Fig 3
Fig 4
Fig 1
Fig 2
The Electrolux Vac & Steam is designed for use on hard-surface floors such as ceramic, stone, marble, vinyl, linoleum,
and sealed hardwood. Do not use on unsealed wood floors. If uncertain, test in an isolated area such as a closet.
NOTE: Heat and steam may remove the sheen on waxed floors or on some no-wax floors. Check use and care
instructions from flooring manufacturer.
C A U T I O N
Be sure Vac & Steam is turned off and
unplugged before removing water tank.
Fill tank with clear water only. Do not use
chemicals, soap
,
detergent
, or vinegar.
Never use Vac & Steam without cleaning pad.
Always direct steam away from yourself. Never
direct steam toward people, animals, or plants.
Be sure dust cup and filter are in place. Slide latch
all the way right, to ‘lock’ position (Fig.1).
Place cleaning pad on floor with Velcro loop strips
facing up. Set floor nozzle onto pad (Fig. 2).
Remove cap and fill tank with tap water. Do not
exceed maximum fill line (Fig. 3). In areas with hard
water, use distilled water for better performance.
Plug in and press steam ‘on’ switch (Fig. 4). Allow
about 15 seconds for unit to produce steam.
Press down front of clean burst pedal to
‘floor mop’ position. Press vacuum ‘on’ switch
(Fig. 5). Use for light vacuuming, on hard
surfaces only.
Hold down floor nozzle and pull handle back
to comfortable angle for using (Fig. 6).
If desired, use vacuum and steam functions
separately.
Do not leave Vac & Steam standing on the
www.electroluxappliances.com
87909rev2_VacSteam.qxp:English 10/15/13 3:08 PM Page 6
Mop
Vac
Mop
Vac
floor for any length of time while damp
cleaning pad is still on it. If you notice a whitish
‘halo’ on the floor surface, it can be removed
with a few drops of vinegar
applied to the floor.
(Do not put vinegar in water tank).
