WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
1
D
A
F
E
C
B
B
C
A
D
G
H*
F
E
J**
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
•
As a stand alone appliance
•
As a combination 27" or 30" Warm & Serve Drawer with a 27" or 30" (76 cm) built-in oven mounted above
IMPORTANT:
The warmer drawer must be installed on a leveled surface from left to right, rear to front and the surface
must be capable of supporting 100 lbs (45 Kg).
P/N 318201809 (0709) Rev. C
English – pages 1-2; Español – páginas 3-4
Français – pages 5-6; Notes - pages 7-8
Warm & Serve Drawer Dimensions
Stand Alone Installation
Combination Warm & Serve Drawer/
27" or 30" (76 cm) Built-in Oven Installation
NOTE:
A 60" (152 cm) long cable is supplied with the
Warm & Serve Drawer.
FLOOR
Warm and Serve
Cutout
Warm and Serve
Drawer
60" (152 cm)
Cord
Minimum distance to floor
41/2" (11,4 cm)
IMPORTANT:
The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
H*
= 11 7/8" (30,2 cm) Min.
is a Critical
dimension and has to be respected
.
Bottom of oven cutout
Caution
: Two 3" (7,6 cm) wide X
3/4" (1,9 cm) thick planks have to
be install and they should be able
to support 200 pounds. (90,7 Kg)
Printed in the USA
J**
= 3" (7,6 cm) Max.
Electrical Junction Box for wall oven must
be lower than warmer drawer cutout.
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11 1/4" (28,6 cm) 27" (68,6 cm)
23 3/8" (59,4 cm)
30" Models
11 1/4" (28,6 cm) 30" (76,2 cm)
23 3/8" (59,4 cm)
D. CUTOUT
E. CUTOUT
F. CUTOUT G. HEIGHT
HEIGHT
WIDTH
DEPTH
27" - Min. 9 7/8" (25,1 cm)
25½" (64,8 cm) 23 5/8" (60 cm) 2" (5,1 cm)
Max. 10 1/4" (26 cm)
25¾" (65,4 cm)
24" (61 cm)
30" -Min. 9 7/8" (25,1 cm)
28½" (72,4 cm) 23 5/8" (60 cm) 2" (5,1 cm)
Max. 10 1/4" (26 cm)
28¾" (73 cm)
24" (61 cm)
Depends on critical
dimension H
Depends on critical
dimension H
D. CUTOUT
E. CUTOUT
F. CUTOUT
HEIGHT
WIDTH
DEPTH
27" Models- Min. 9 7/8" (25,1 cm)
25 1/2" (64,8 cm)
23 5/8" (60 cm)
Max. 10 1/4" (26 cm)
25 3/4" (65,4 cm)
24" (61 cm)
30" Models- Min. 9 7/8" (25,1 cm)
28 1/2" (72,4 cm)
23 5/8" (60 cm)
Max. 10 1/4" (26 cm)
28 3/4" (73 cm)
24" (61 cm)
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11 1/4" (28,6 cm) 27" (68,6 cm)
23 3/8" (59,4 cm)
30" Models
11 1/4" (28,6 cm) 30" (76,2 cm)
23 3/8" (59,4 cm)
