6
www.electrolux.com
4. CONTROLS
Button
Basic function
Indicator lights
Dual Function
L
Press briefly to turn the lighting system on and off.
Button off.
Lights off.
Press and hold the button for 2 seconds to activate
the lighting system in “courtesy light” mode. The lights
are lit at a reduced power of approximately 5W. This
function can be disabled by pressing the button once
again for 2 seconds or by pressing it briefly to switch
to normal lighting mode.
Button lit.
Lights on.
Button lit.
Courtesy light on.
T1
Turns the motor off from whatever speed it is set to.
Button lit.
Motor active.
Motor inactive.
Press and hold the button for 3 seconds with all the
loads turned off (Motor and Lights), to turn the Activated
Charcoal Filter alarm on/off.
Button flashes twice
F
– Alarm On.
Button flashes once
F
– Alarm Off.
T2
Turns the motor on at speed one.
Button on.
T3
When pressed briefly, turns the motor on at speed two.
Button on.
Speed two on.
Press and hold the button for approximately 2” to turn
the Delay function on and off, that is to say to turn the
appliance off after a 20 minute delay. Suitable to complete
elimination of residual odours. Can be activated from
the OFF position and from speeds 1, 2, 3. Cannot be
activated with Intensive speed On.
Buttons flashing
(
T1
+
T2
or
T3
or
T4
).
Delay functionActive.
T4
Turns the motor on at speed three.
Button on.
T5
Turns the motor On and Off at Intensive speed for a
timed period of 5 minutes. At the end of the 5 minutes
the appliance will automatically return to the speed
that was set before. If the appliance was turned off at
the time of activation, at the end of the 5 minutes the
system will return to speed one.
Button on.
F
Press and hold for 4 seconds to reset the filter alarm
indicator, shown by flashing of button
T1
. This procedure
can only be carried out with the motor off.
Button on
Signals the Metal Grease
Filter saturation alarm, indi-
cating that it is necessary to
wash the filters. The alarm
is triggered after the Hood
has been in operation for
100 working hours.
Button flashing
When this is activated, it sig-
nals the Activated Charcoal
Filter saturation alarm, indi-
cating that the filter must be
changed; the Metal Grease
Filters must also be washed.
The Activated Charcoal Filter
saturation alarm comes into
operation after the Hood has
been working for 200 hours.
