Electrolux WOL6035CN, User Manual

4

www.electrolux.com

1. RECOMMENDATIONS  

  AND SUGGESTIONS

• The Instructions for Use apply 

to several versions of this ap-

pliance. Accordingly, you may 

find descriptions of individual 

features that do not apply to 

your specific appliance.

• The manufacturer will not be 

held liable for any damages 

resulting from incorrect or 

improper installation.

• The minimum safety distance 

between the cooker top and 

the extractor hood is 650 

mm (some models can be 

installed at a lower height, 

please refer to the paragraphs 

on working dimensions and 

installation).

• Check that the mains voltage 

corresponds to that indicated 

on the rating plate fixed to the 

inside of the hood.

• For Class I appliances, check 

that the domestic power sup-

ply guarantees adequate 

earthing. Connect the extrac-

tor to the exhaust flue through 

a pipe of minimum diameter 

120 mm. The route of the flue 

must be as short as possible. 

• Do not connect the extractor 

hood to exhaust ducts carry-

ing combustion fumes (boil-

ers, fireplaces, etc.).

• If the extractor is used in con-

junction with non-electrical 

appliances (e.g. gas burn-

ing  appliances),  a  sufficient 

degree of aeration must be 

guaranteed in the room in 

order to prevent the backflow 

of exhaust gas. The kitchen 

must have an opening com-

municating directly with the 

open air in order to guarantee 

the entry of clean air. When 

the cooker hood is used in 

conjunction with appliances 

supplied with energy other 

than electric, the negative 

pressure in the room must not 

exceed 0,04 mbar to prevent 

fumes being drawn back into 

the room by the cooker hood. 

• In the event of damage to 

the power cable, it must be 

replaced by the manufacturer 

or by the technical service de-

partment, in order to prevent 

any risks. 

• If the instructions for installa-

tion for the gas hob specify 

a greater distance specified 

above, this has to be taken 

into account. Regulations 

concerning the discharge of 

air have to be fulfilled.

• Use only screws and small 

parts in support of the hood. 

Warning: 

Failure to install the 

screws or fixing device in ac

-

cordance with these instruc-

tions may result in electrical 

hazards.

• Connect the hood to the mains 

through a two-pole switch 

having a contact gap of at 

least 3 mm.