44 ENGLISH
CLEANING AND MAINTENANCE
Cleaning is the only maintenance
action that is required normally.
Warning! Cleaning must be done with
the crockery warmer disconnected
from the electrical power supply.
Remove the plug from the power
socket or disconnect the crockery
warmer power supply circuit.
Do not use aggressive or abrasive
cleaning products, abrasive sponges or
pointed objects since stains or
abrasion marks may appear.
Do not use high pressure or steam jet
cleaning appliances.
APPLIANCE FRONT AND
CONTROL PANEL
The crockery warmer can be cleaned
using just a damp cloth. If it is very
dirty, add a few drops of washing-up
liquid to the washing water.
Wipe the surfaces dry using a dry
cloth.
For stainless steel fronted crockery
warmers, special products for
treatment of stainless steel surfaces
can be used. These products prevent
the surfaces becoming dirty again for
some time. Apply a thin layer of such a
product on the surface using a soft
cloth.
On aluminium fronted crockery
warmers use a gentle glass cleaning
product and a soft cloth that does not
release fluff. Wipe horizontally without
pressing on the surface since
aluminium is sensitive to scratches and
cuts.
INTERIOR OF THE
CROCKERY WARMER
Clean the inside of the crockery
warmer regularly using a damp cloth. If
it is very dirty add a few drops of
washing-up liquid to the washing water.
Wipe the surfaces dry using a dry
cloth.
Avoid water entering through the air
circulation opening.
Only use the crockery warmer again
when it is completely dry.
MAT WITH NON-SLIP
SURFACE
The non-slip surface mat can be
removed to facilitate cleaning of the
drawer.
The mat can be cleaned by hand using
hot water with a few drops of washing-
up liquid.
Dry thoroughly.
The non-slip mat should only be
replaced when it is completely dry.
