13
1
Open the
POLY CONFIG
menu by pressing
[FUNCTION]
+
[KIT]
. Select the menu options by pressing the
[UP]
/
[DOWN]
arrow keys.
2
Select any combination of the four
VOICES
to be poly enabled by using the
[LEFT]
and
[RIGHT]
arrow keys. Tick or
untick a box by pressing the
[YES/SAVE]
key. Voices that are not set to be poly enabled will be dedicated monophon-
ic voices for their corresponding tracks. These will never be used for polyphonic playback. Voices that are set to be
poly enabled will be allocated dynamically by any of the poly enabled tracks.
3 ALLOCATION
changes the allocation cycle of the four voices, or sets all four voices to play simultaneously (
RESET
,
ROTATE
,
REASSIGN
or
UNISON
, respectively). Select mode with the
[LEFT]
and
[RIGHT]
arrow keys.
4
Select
USE TRK SOUNDS
if you want to force the selected voices to use the Sounds of the four tracks, instead of letting
the voices use the played Sound in a dynamic way. Tick/untick box to activate/deactivate using the
[YES/SAVE]
key
or the
[LEFT]
and
[RIGHT]
arrow keys.
In the POLY CONFIG menu, you can activate/deactivate voice 1-4 directly. Just press [TRIG] key 1 through 4.
When in the POLY CONFIG menu, the red LEDs above [TRIG] key 1-4 will be half-bright. When a voice is acti-
vated, the corresponding LED will light up full-bright.
EDITING A SOUND
1
Select one of the synth tracks by pressing
[TRACK]
keys 1-4. The Sound of the active synth track is the one that will
be edited.
2
Adjust the overall volume level of the active track with the
LEVEL
knob.
3
Edit a Sound by adjusting the parameters found on the synth track
PARAMETER
pages. Access these pages by pressing
the
[PARAMETER]
page keys. If a page contains a subpage, press the
[PARAMETER]
page key again to access it. Use
the
DATA ENTRY
knobs to change the parameters.
OSC1
controls oscillator 1. Contains one sub page for the noise generator.
OSC2
controls oscillator 2. The sub page hosts parameters relevant for both oscillators.
FILTERS
controls the two filters and the overdrive. One 24 dB/octave 4-pole lowpass ladder filter and
one 2-pole multimode filter are available, connected in series with the overdrive between them.
AMP
contains parameters for the amplitude envelope. Effect sends are found here as well.
ENV
offers two freely assignable envelopes. The first one also controls the filters. The second enve-
lope is located in a subpage.
LFO
is where parameters for the two freely assignable LFOs are found. Contains one subpage.
EDITING THE FX AND CV TRACKS
Editing the FX and CV tracks is very similar to editing the Sounds of the synth tracks of the active kit. The
PARAMETER
pages contain parameters relevant for the two types of track.
THE NAMING MENU
The naming procedure is identical for the various naming menus that will appear when Sounds, kits, et cetera are saved
or renamed.
Summary of Contents for Analog Keys
Page 1: ......