Aut
oSense & Aut
oSense V
oice
24
24
completely (see picture in
“Strip insertion and use”
paragraph in
“About
Test Strip”
). An insufficient amount of blood might result in significant
inaccuracy or failure of the test.
3.
The flashing blood drop icon will stop flashing when the blood droplet
touches the strip. A flashing horizontal bar in the middle of the display
indicates that the meter is performing the test. The measurement is
performed automatically. Do not move or touch the strip during this time.
4.
On average measurements are made 5 seconds,
after which the result is automatically displayed.
AutoSense Voice
not only displays but also vocalizes
the result in a human voice.
The meter will display “Lo”
if the measured value is below 1.1 mmol/l (20 mg/dl)
and “Hi” if the value exceeds 33.3 mmol/l (600 mg/dl).
5.
When the result is displayed, you may mark (!) and/
or flag it with the
SET
button. If the
SET
button is pressed again, the next
marking/flagging combination appears. For more information, refer to
"
Flagging and marking test results"
.
D61-9201-2_ beliv.indd 24
D61-9201-2_ beliv.indd 24
2012.11.13. 15:32:15
2012.11.13. 15:32:15
