ElectroSmash pedalSHIELD UNO How To Build Download

Page: 2 / 6

Step 1 – Soldering Resistors.

There are 13 resistors to be placed:

•

Solder the 4.7KΩ resistors (7 units): R3, R4, R6, R9, R10, R12, R13.

•

Solder the 100KΩ resistors (3 units): R5, R7, R8.

•

Solder the 1M resistors (2 units): R1, R2.

•

Solder the 1.2M resistor: R11.

tips:

- In order to solder the components, bend the leads close to the

body, introduce them in the footprint and once soldered cut the
excess of lead as short as possible to avoid short circuits.

There is a

to learn how to solder from

scratch.

Summary of Contents for pedalSHIELD UNO

Page 2: ...er the 100KΩ resistors 3 units R5 R7 R8 Solder the 1M resistors 2 units R1 R2 Solder the 1 2M resistor R11 tips In order to solder the components bend the leads close to the body introduce them in the footprint and once soldered cut the excess of lead as short as possible to avoid short circuits There is a nice video on Youtube to learn how to solder from scratch ...

Page 3: ... C5 C7 C8 C9 Solder the 4 7uF capacitors 3 units C3 C6 C10 Solder the 100nF capacitors 2 units C1 C11 Solder the 270pF capacitor C4 tips Be careful with the electrolytic caps polarity the negative lead the short one has to be placed in the round hole with the white semicircular paint The positive hole is always square shaped zoom the above image to be sure ...

Page 4: ...last components to be placed are the dip sockets resistor trimmer and led tips Take care with the LED D1 soldering present the plastic cover to size the length of the leads The short lead cathode it is marked with a K on the PCB and goes to the flat side of the diode mark ...