COMPONENTS. PART 1: STAND / FAN BASE.
1. Removable base bars (A and B).
2. Foots.
3. Screws.
4. Mast extensible in height.
5. Mast fixing nut.
6. Cover for screws.
7. Extensible mast inner tube.
ASSEMBLY.
1. Assemble the structure of the cross base, inserting the bar "B" into the bar "A".
2. Put the foots on each end of the bars.
3. Put the extendable mast and screw it to the cross base structure.
4. Remove the mast nut (5) so that the screw cover (6) can enter.
5. Once the cover screws (6) is inserted, replace the mast nut (5).
6. Extend the mast by loosening the nut (5) and pulling up the inner tube (7).
7. Set the inner tube (7) to the desired height and re-tighten the mast nut (5).
8. Insert the fan body and tighten. (Assembly explained in the following section).
NOTE.
Each of the pieces of the photos in this section may be subject to small
variations in the piece model.
In any case they are mounted in the same way and following the same steps.
