19
HOW TO ADJUST WATER TEMPERATURE FOR
HIGH ALTITUDE TO AVOID BOILING
HOW TO ADJUST WATER FILLING AMOUNT
In order to extract most of flavor from your Single Serve Cup your Brewer works at 201
0
F. It is
good for elevations under 3500 feet.
For higher altitudes need to reduce water boiling temperature.
Follow instructions to make correct settings:
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time , touch buttons “Pre-heat” and “Brew” for 1 seconds, to enter into SET mode.
You will see 3 LED flashing for cup sizes.
- For altitude under 5500 Feet, you should touch button for “ Small cup” for 1 second, until “Small
cup” LED will flash. Then touch BREW button to SET.
- For altitude under 7700 Feet , you should touch “Middle Cup” button for 1 second, until “Middle
cup” LED will flash. Then touch BREW button to SET.
- For altitude under 10,000 Feet elevation, you should touch “Big cup” button for 1 second, until
“Big cup” LED will flash, then touch BREW button to SET.
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time , touch together buttons for “Middle Cup” and “Brew” for 1 second, water will
start dispensing from the Brewer. When water reaches required level desired for middle cup
setting touch “Brew” button to stop dispensing. Setting for middle cup is completed. Output
settings for “Small Cup” and “Big Cup” will be adjusted accordingly.
Note: To return to factory settings unplug the power cord and plug back again after 3 seconds.
HOW TO CANCEL BLOW OFF TO DRY CUPS WITH OPEN BOTTOM
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time, touch together buttons for “PRE-HEAT” and “Small Cup” for 1 second, to enter
into SET mode. My Cup light starts flashing.
- Touch “Brew” button to cancel Blow Off function. LED light for K-cup picture will turn OFF.
