Page 11 of 20 M6847 issue 1.1
Note:
On initial start-up from cold, the amber neon will be on continuously and will
subsequently switch on and off with reducing ‘on’ periods as the required
temperature setting is approached.
For more accurate temperature setting, check bath water temperature using a hand
held thermometer or other suitable temperature measuring device and adjust the
regulating knob as required.
7.5. If an over temperature condition occurs, the bath heater mat will turn off. Disconnect
from the mains electricity supply and check there is sufficient distilled water in the
bath. When the unit has cooled down the thermal cut out will reset and operation
may recommence. If a lack of distilled water isn’t the reason for the over temperature
fault condition, refer to section 10 Customer support.
Take care not to get hot distilled water onto hands /skin
7.6. Regularly check the volume of distilled water present in the unit. Replenish as
required.
7.7. An optional lid can be purchased which reduces evaporation of bath water – order
part code AZ9241.
