38
ELECTRICAL CONNECTION
•
The installation of this appliance and the connection to the electrical system should be
entrusted only to a qualified electrician.
•
Protection against the parts under tension must be ensured after instalation
•
The data of connection necessary are on the stickers place on the hob casing near the
connection box.
•
The connection to the mains must be made using an earthed plug or via an omnipolar
circuit breaking device with a contact opening of at least 3 mm.
•
The electrical circuit must be separated from the network by adapted devices, for
example: circuit breakers, fuses or contactors.
•
If the appliance is not fitted with an accessible plug, disconnecting means must be
incorporated in the fixed installation, in accordance with the installation regulations.
•
The inlet hose must be positioned so that it does not touch any of the hot parts of the hob
or even.
Caution!
•
This appliance has only to be connected to a network 230 V~ 50/60 Hz
•
Always connect the earth wire.
•
Respect the connection diagram.
•
The connection box is located underneath at the back of the hob casing. To open the
cover, use a medium screwdriver. Place it in the slits and open the cover.
Mains
Connection
Cable diameter
Cable
Protection calibre
230V~1N 50/60Hz
1 Phase + N
3 x 2,5 mm²
H 05 VV - F
H 05 RR - F
25 A *
400V~2N 50/60Hz 2 N
4 x 1.5 mm²
H 05 VV - F
H 05 RR - F
16 A *
( * ) calculated with the simultaneous factor following standard EN 60 335-2-6
Setting up the configurations:
For the various kinds of connection, use the brass links which are in the box next to the terminal
block. Except for where the appliance is pre-wired.
