Solar Powered RC Controlled LED Smart Street/Parking Lot Lighting
12346 Valley Blvd, El Monte, CA 91732 USA
Phone Number: 1-877-579-3889 Fax Number: (626) 452-9194 www.eesgi.com /www.eleding.com/
Rev: 01042018
EE Systems Group Inc.
2-
1
Installation Instruction
eLEDing
®
/ EE800W-SHRC series
Thank you for choosing eLEDing!
Introduction and Intellectual Property Rights Statement
This product is designed to provide years of trouble-free services by using environment-friendly Solar-Hybrid-Lithium based energy
technologies. Covered under US, European, China and other international patents granted and pending worldwide. All rights reserved.
The performance of this unit is highly related to its mounting location, direction of the solar panel, weather conditions and local environment.
Therefore, to maximize the performance of the unit, read instruction carefully before installation. DIY user(s) must have knowledge of AC/
DC electric/electronic projects and related construction/installation experiences. Otherwise, consult with local experienced electrical &
electronics installers or technicians for assistance. Before installation, be aware of and comply with local construction laws, electrical code
and life & safety standards/regulations that are applied for this lighting project. During installation, please follow proper safety guidelines to
prevent any possible accidents or injuries.
Easy Activation & Setup
This light unit is fully charged before shipping, but switch the light OFF to pre-charge 1-2 days under sunshine before installation is
recommended. The solar panel works as ambient light sensor to control the lighting system. During daytime testing, put the light on the table
with solar panel side facing down, or fully cover the solar panel with package box or cardboard, to simulate nighttime environment.
Momentary press the switch to turn on the light and activate the system (Fig.1&2), then use remote control to set up your preferred lighting
mode and lighting profile. Remove the cardboard or expose the solar panel, the light will turn off automatically. If the light function as
described above, the light is function normal and ready for installation.
Smart Lighting Profile with Remote Control
Under eLEDing’s Intelligent Power Management (IPM) system, the light offers Dusk-to-Dawn lighting and auto power compensation during
critical weather and different geographic locations. During nighttime, the low ambient light level will trigger the light to provide all-night-long
illumination based on your preset lighting mode & lighting profile. Selectable lighting modes & profiles as below chart shows:
e
LE
D
in
g
(Patented Technology)
Fig.1
Fig.2
Fig.3
Installation Guidelines
1. Follow above standard setup procedure to activate the lighting system (Fig.2)
2. Securely mount the unit on the light pole, adjust the light head direction based on your need (Fig.3)
3. The light will automatically shut down and charge during daytime sunshine condition (Fig.3)
4. Suggested Mounting Height: 15-20 ft (Fig.4)
5. Diameter of Mounting Adaptor: SHRC30 & SHRC40 (3"); SHRC50 & SHRC60 (3-3/8”), refer (Fig. 4)
6. Fixed light head angle to ground: 15 degrees or by fixed MFC
7.
Solar Panel Direction:
The solar panel must be mounted in a non-obstructed position where it will receive an average of at least 5 hours daily
direct sunlight all year round. For Northern hemisphere installations the solar panel can be mounted facing to East-South-West with direct
southerly facing position is best and visa-versa for Southern hemisphere installation. As a option as required, AUX DC power sources can be use
either for quickly charge light unit before installation, or/and for poor sunshine location or position with back-up power source or as a charging
enhancement method (Fig. 5)
8.
Solar Panel Maintenance:
Use a soft wet cloth to periodically (at least once a one year) clean the solar panel to avoid the reduction of energy
output due to accumulated dust. Clean accumulated snow as soon as possible during the snowing season.
Battery for
Remote Control:
23A, 12V
