15
ENGLISH
A
Danger!
Prior to all servicing:
−
Switch Off.
−
Unplug.
−
Wait until the compressor has
come to a complete stop.
−
Ensure the compressor and all air
tools and accessories connected
to it are relieved from pressure.
After all servicing:
−
Check to see that all safety
devices are operational.
−
Make sure that no tools or other
parts remain on or in the
machine.
Compressor does not run:
•
No mains voltage.
−
Check cables, plug, outlet and
mains fuse.
•
Mains voltage too low.
−
Use only extension cables with
sufficient lead cross section (see
"Technical Specifications"). Avoid
using extension cable with cold
machine.
•
Compressor was stopped by
unplugging.
−
Switch compressor OFF at the
On/Off switch, then ON again.
•
Motor has overheated, caused by
insufficient cooling (cooling fins cov-
ered).
−
Remove cause for overheating
and allow to cool down for
approx. 10 minutes, then start
again.
Compressor runs but does not build
up sufficient pressure.
•
Drain cock on cup of filter/regulator
unit open.
−
Close drain cock.
•
Check valve leaky.
−
Have check valve serviced by
qualified service centre.
Air tool is not supplied with sufficient
pressure.
•
Pressure regulator not opened wide
enough.
−
Open pressure regulator more.
•
Hose connection between compres-
sor and air tool leaky.
−
Check air hoses, replace defec-
tive parts if necessary.
A
Danger!
Repairs to electric tools must
be carried out by qualified electrici-
ans only!
Electric tools in need of repair can be
send to the service centre in your coun-
try. See spare parts list for address.
Please attach a description of the fault to
the electric tool.
The machine's packaging can be 100 %
recycled.
Worn out machines and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on chlo-
rine-free bleached paper.
7.
Trouble Shooting
8.
Repairs
9.
Environmetal protection
10. Technical Specifications
Suction capacity
l/min
380
Free air delivery (volume flow rate)
l/min
240
Filling rate
l/min
280
Working pressure (compression end pressure)
bar
10
Pressure vessel volume
l
60
No. of air outlets
2
Compressor pump type
B 3800 B
No. of cylinders
2
Speed (compressor pump)
min
-1
1150
Motor capacity
kW
2.2
Supply voltage (50 Hz)
V
230
Rated current
A
12.5
Fuse protection min.
A
16 (time-lag)
Degree of protection
IP 54
Max. overall cable length when using extension cables:
– at 3 x 1.5 mm
2
lead cross section
– at 3 x 2.5 mm
2
lead cross section
m
m
15
25
Oil grade (compressor pump)
SAE 40
Required oil quantity (compressor pump)
l
1.0
Dimensions length x width x height
cm
110 x 46 x 81
Weight
kg
79
Sound pressure level L
PA
at 4 m max.
dB (A)
72 ± 3
Sound power level L
WA
dB (A)
92
