66
© 2006, Elektro-Automatik GmbH & Co. KG
Irrtümer und Änderungen vorbehalten
EN
Instruction Manual
PSI 8000 3U Series
Date: 05-03-2012
Using the power supply
Notifications of the set/actual comparison
Example: The step from a lower set value to a higher set value
was not performed within the settling time
Tsr.
The supervi-
sion error is then notified as alarm, warning or signal.
U
or
U or
U
Depending on the configuration of
Step response,
the
I
condition is alternatively notified.
Example: The step from a higher set value to a lower set value
was not performed within the settling time
Tsf.
The supervi-
sion error is then notified as alarm, warning or signal.
U
or
U
or
U
Depending on the configuration of
Step response,
the
I
condition is alternatively notified.
Part 2: The menu
Options
Options
+
The menu entry
Options
leads you to following menu se-
lection:
Reset configuration
Enable R mode
Setup lock
7.7 Reset to default configuration
You can reset all modifications of the setup to the default setup
(the state the unit had when it was delivered).
After selecting the corresponding menu entry you will be promp-
ted again to submit the choice to reset your current, personal
configuration.
Attention!
Even if the device configuration has been locked by
a PIN it will be unlocked and overwritten!
Reset configu
Are you sure ?
Default:
NO
= YES
All modifications of the default setup are reset
= NO
No change
7.8 Unlocking the U/I/R mode
R mode available:
YES
The U/I/R operation is unlocked and can be used
NO
U/I/R operation not enabled yet
The U/I/R operation mode can only be used after it was unlocked
with a PIN code. This mode also has to be configured in the
profile (see also „7.1 Defining operation parameters“).
In order to unlock the feature, a PIN code is required, which can
purchased optionally. Please contact your supplier. The device‘s
serial number, which can be found on the type label, is required
to be told, because the code is related to it.
Enable R mode +
Activate R mode via pin code:
0 0 0 0
Use the code you got from your supplier. It consists of 4 numbers
of 0...15.
7.9 Locking the device configuration
Setup lock +
It can be necessary, for security reasons, to lock the device
configuration from access. You can enter a PIN code here,
consisting of 4 numbers, each from 0 to 15.
Attention!
This only effects the user profile of the device, not
the set values or the rotary knobs on the front panel!
Lock setup via
Enter the PIN code
pin code:
{0..15} {0..15} {0..15} {0..15}
The lock can only be disabled with the same PIN code or by
resetting the configuration with
Reset configuration
.
This will reset the configuration to factory setting. It also deletes
the custom setup and can be used in case the PIN code for
setup lock has been lost.
If you activate the setup lock with a code you can only change
the configuration again after the code was entered anew.
