12. MIDI TRACK PARAMETERS
51
12.6.6 PHAS
Start Phase sets the point within the wave cycle where the LFO will start when it is trigged. 0 makes the
LFO start at the beginning of a complete wave cycle, 64 makes it start at the center. A small square at
the start of the waveform shows that the wave cycle starts at a zero-crossing. (0–127)
12.6.7 MODE
Trig Mode sets how the LFO will act when a note is trigged.
• FRE
is the default free-running mode. It makes the LFO run continuously, never restarting or
stopping even if notes are trigged..
• TRG
makes the LFO restart when a note is trigged.
• HLD
makes the LFO run free in the background, but when a note is trigged the LFO output level is
latched and held still until the next note is trigged.
• ONE
The LFO starts when a note is trigged, then runs to the end of the waveform and then stops.
This makes the LFO function similar to an envelope.
• HLF
The LFO starts when a note is trigged, then runs to the middle of the waveform and then stops.
12.6.8 DEP
Depth sets the depth and polarity of the LFO modulation. Both negative (inverted) and positive modula-
tion depth is possible. A center setting, 0.00, equals no modulation depth. (-64.00–63.00)
Summary of Contents for Digitakt
Page 1: ...Digitakt User Manual...
Page 84: ...4116ENG O...