15. SETTINGS MENU
68
The column to the left selects what will be received. Select the column using the
[LEFT]
arrow key. Use
the
[UP]
/
[DOWN]
keys or the
TRACK LEVEL
knob to navigate in the column. The SysEx data receive
alternatives located in the column to the right will change depending on the selection made in the left
column. Press the
[RIGHT]
arrow key to access this column. Use the
[UP]
/
[DOWN]
keys or the
TRACK
LEVEL
knob to select what will be received. Press
[YES]
to initiate the SysEx receive procedure. The
Digitakt starts listening to incoming data. Press
[NO]
to stop listening.
PATTERN
will store a received pattern to the selected pattern slot.
SOUNDS
will store a received Sound to the selected slot of the +Drive Sound library. The option
ANYWHERE will place the Sound in the first free slot available. To the right of the bank indication, the
amount of free slots can be seen.
15.5 AUDIO ROUTING (GLOBAL)
Here you find number of audio routing options that affects the Digitakt on a global level. You can also set
the audio routing on a pattern level. For more information, please see “10.5.6 AUDIO ROUTING (PATTERN)”
15.5.1 ROUTE TO MAIN
Use this option to customize which of the 8 2 effects (Delay, Reverb) that sends audio through
the master effect (Compressor) to the MAIN OUT outputs. Use the
[TRIG 1–8]
keys and the
[FLTR]
, and
[AMP]
keys to activate/deactivate send from each track and effect. Green keys signal send to main. Red
keys signal do not send to main. Note that each track still sends to its TRACK OUTPUTS.
15.5.2 SEND TO FX
Use this option to customize which of the 8 the Delay effect that sends audio to the effects
(Delay, Reverb). Use the
[TRIG 1–8]
keys and the
[FLTR]
key to activate/deactivate send from each track
and effect. Green keys signal send to the effects. Red keys signal do not send to the effects.
15.5.3 INT TO MAIN
Sets if Digitakt sends internal audio to the MAIN OUT and HEADPHONES OUT or not when used with
Overbridge or as a class compliant audio device.
OFF
No sound is sent to main out.
ON
Sound is always sent to main out.
AUTO
No sound is sent to main out when Overbridge is available and/or streaming audio, if not, the
sound is sent to main out.
15.5.4 USB TO MAIN [dB]
Sets the amount of amplification of the sound that is streamed over USB to the Digitakt main out when
used with Overbridge or as a class compliant audio device. (0 dB–+18 dB)
15.5.5 PRE/POST FADER
S
ets if audio over USB should be pre or post the track level setting.
Summary of Contents for Digitakt
Page 1: ...Digitakt User Manual...
Page 84: ...4116ENG O...
