13. FX AND MIXER PARAMETERS
53
TIME setting Divide ratio
42.67
1/3 (1/2T)
48
1/4.
64
1/2
96
1/2.
128
1
13.2.2 X
Ping-pong sets the delay signal to alternate across the stereo field. There are two settings:
• OFF
lets you manually set the position of the delay signal in the stereo field. Use the WID parameter
to change the stereo field position.
• ON
makes the delay signal alternate between left and right pan positions. The WID parameter
controls the amount of panning.
13.2.3 WID
Stereo Width sets the delay signal pan width across the stereo field. The knob is bipolar. (-64.00–63.00)
13.2.4 FDBK
Feedback Gain sets the amount of delay output signal to feed back into the input of the delay. With high-
er parameter settings, infinite and/or swelling delays are possible. Please be aware that high feedback
can lead to a very loud signal. (0–198)
13.2.5 HPF
Feedback HPF sets the cutoff frequency of the delay highpass filter. (0.00–127.00)
13.2.6 LPF
Feedback LPF sets the cutoff frequency of the delay lowpass filter. (0.00–127.00)
13.2.7 REV
Reverb Send sets the amount of Delay output signal to be sent to the Reverb. (0.00–127.00)
13.2.8 VOL
Mix Volume adjusts the volume of the Delay output signal. (0.00–127.00)
13.3 REVERB
The Reverb send effect controls the persistence, and ambient characteristics, of the sound reverberations.
It can simulate many different sonic locations, from huge spaces to small rooms.
Press
[FUNC]
+
[AMP]
to access this parameter page.
13.3.1 PRE
Pre-delay sets the pre-delay time of the Reverb. (0.00–127.00)
13.3.2 DEC
Decay Time sets the length of the decay phase of the reverberated signal, essentially setting the size of
the acoustic space. (1–127, INF)
Summary of Contents for Digitakt
Page 1: ...Digitakt User Manual...
Page 84: ...4116ENG O...