KERCOMET 170
and
210, MULTIMIG 150
Start-up
20
13.4 Characteristic connection
Fig. 20: Characteristic table and selection knob
The characteristic selection knob 65 and the
corresponding table are in the wire feed
casing.
The table content may differ from
your welding machine. The char-
acteristic lines are set individually
for each machine type.
Select
the
required
material-wire-gas
combination from the characteristic table.
Read the corresponding characteristic
number off from the right hand column.
Set the corresponding number from the
table using selection knob 65.
Below the characteristic number 0 (manual
mode)
•
Is
the
material-wire-gas
combination
nullified. Wire feed and welding voltage can
be set manually.
•
The welding step (Basic Plus) instead of
material thickness will be displayed.
•
The must-value for welding voltage (Control
Pro) instead of material thickness will be
displayed.
If an unassigned number is set with
the characteristic selection knob 65,
the
7-segment-display
47
will
display the error message „noP“.