2
making any unusual noise or vibration, im-
mediately switch off and allow the cutter
to stop. Remove the plug from the mains
supply and take the following steps:
– Inspect for damage.
– Replace or repair any damaged parts.
– Check for and tighten any loose parts.
Do not attempt to repair the machine un-
less you are qualified to do so.
Do not allow processed material to build
up in the discharge zone; this may prevent
proper discharge which can result in kick-
back of material through the chute assem-
bly.
If the machine becomes clogged, switch
off and allow the cutter to stop. Remove
the plug from the mains supply before
clearing debris.
Check if guards and protective devices are
undamaged and properly mounted. Before
using, carry out possibly necessary mainte-
nance and repairs.
Do not tamper with the motor speed con-
trol settings. Contact a ELEM GARDEN
TECHNIC approved
service agent if a problem exists.
Keep the motor cooling vents clean of de-
bris and other accumulations to prevent
damage to the motor or possible fire.
Never pick up or carry the machine while
the motor is running.
Switch off, allow the cutter to stop and re-
move the plug from the mains supply
whenever you leave the work area.
Do not tilt the machine while it is running.
Do not expose the machine to rain. Only
store the machine in a dry place.
Maintenance and Storage
When the machine is stopped for servicing,
inspection, or storage, or to change an ac-
cessory, switch off and remove the plug
from the mains supply and allow the ma-
chine to cool. Make sure that all moving
parts have come to a complete stop before
making any inspections, adjustments, etc.
Maintain the machine with care and keep it
clean.
Examine the machine and replace worn or
damaged parts for safety.
Ensure replacement parts fitted are ELEM
GARDEN TECHNIC
approved.
If an extension cord is used it shall not be
of lighter grade than the supply cord al-
ready fitted to the machine.
Check the supply and any extension cord
regularly for damage or signs of ageing. Do
not use the machine,
if the cords are damaged.
When servicing the cutter be aware that,
even though the motor will not start due to
the interlock feature of the guard, the cut-
ter can still be moved if the motor is turned
by hand.
Never attempt to override the interlock
feature of the guard.
