start due to the interlock feature of the guard,
the cutting means can still be moved by a
manual starting mechanism.
Additional safety instructions for units with
bagging attachments
§ Shut-off the power unit before attaching or
removing the bag.
6 SAFETY WARNINGS GASOLINE
WARNING: Use extra
care in handling fuels.
They are flammable and
the vapours are
explosive. The following
points must be observed.
§ Use only an approved container.
§ Never remove the fuel cap or add fuel with
the power source running. Allow engine
exhaust components to cool before refuelling.
§ Do not smoke.
§ Never refuel the machine indoors.
§ Never store the machine or fuel containers
inside, where is an open flame, such as a
water heater.
§ If fuel is spilled, do not attempt to start the
power source, but move the machine away
from the area of spillage before starting.
§ Always replace and securely tighten the fuel
cap after refuelling.
§ If the tank is drained, this should be done
outdoors
7 ASSEMBLY INSTRUCTIONS
Hopper installation
§ Carefully lift up the hopper
§ Place and align the hopper on top of the
hopper seat.
§ Locate the screw to secure the hopper with
the base unit.
Wheel installation
§ Lift the machine a little, and reeve the wheel
with the wheel shaft.
§ Reeve a washer, and insert a pin to fix.
§ Repeat above processes to install another
wheel
Move the shredder
§ Stand at the back of shredder
§ Grab the hopper handle, and step on the
wheel axle.
§ Pull down the handle to slant backward the
shredder.
§ Move the shredder.
Summary of Contents for BVT50-159CC
