Elenco Electronics M-1007K, Assembly And Instruction Manual

Figure I

Spring

Solder pad
on PC board

-6-

Close-up view of the

transistor socket and

PC board.

Solder Side

Figure E

Tab

Input Sockets

Shunt Wire

Red Wire

Black Wire

Solder

Battery Snap

Transistor

Socket

Fuse Clips

r

Remove the clear protective film from the
front of the LCD as shown in Figure F. 
(Note: DO NOT remove the white backing
on the other side of the LCD).

r

Insert the LCD into the case (the tab on
the LCD must be in the same direction
shown in Figure G). Be sure to insert the
LCD under the tab on the case as shown
and push the edge of the LCD against the
raised area on the case. Press into place.

r

Place the zebra onto the grooved surface
of the LCD as shown in Figure H. Carefully
place the zebra clip around the zebra and
the raised area on the case.

r

Solder the spring to the solder pad on the
the legend side of the PC board as shown
in Figure I.

r

Cut open the plastic envelope containing
the grease and put a small amount of
grease in each spring hole of the selector
knob as shown in Figure J. Then, insert a
1/4” spring into each hole as shown in the
figure.

Clear
Protective Film

Figure J

Spring Holes

1/4” Springs

Figure F

LCD

Tab

Top Case

Tab

Zebra

Zebra Clip

Figure G

Figure H

Raised Area
on Case

Raised Area
on Case