Warnhinweise
Program other AstroTec-868 transmitters
Delete AstroTec-868 transmitters
EN-21
EN
Deleting individual transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Press the following buttons simultaneously:
• Programming button P (on back of device)
• STOP button (on front of device)
2. Keep these two buttons pressed until the LED goes out briefly
(approx. 3 seconds).
Deleting all transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Press the following buttons simultaneously:
• Programming button P (on back of device)
• UP button
• STOP button
• DOWN button
2. Keep all of these buttons pressed until the LED goes out.
on front of device
}
Programming additional transmitters
To programme additional transmitters in one receiver, please proceed
as follows:
1. Press the UP, DOWN and programming button P on a transmitter
that has already been programmed in the receiver until the LED
goes out.
2. To define the keyboard layout, press the UP button on the hand-
held transmitter as soon as the shutter/blind begins to move
upwards (after approx. 1 second).
The shutter/blind will come briefly to a halt.
As soon as the shutter/blind begins to move again, press the
DOWN button on the handheld transmitter.
The shutter/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
AstroTec-868_AstroTec-868_bidi EN_0412.indd 21
stroTec-868_AstroTec-868_bidi EN_0412.indd 21
12.04.2012 17:31:14
12.04.2012 17:31:14
