elero AstroTec-868 bidi, Operating Instructions Manual

Explanation of functions 

18 | EN 

FUNCTION
This mode is intended for qualified electricians only! 
(Will only appear when the operating device is disconnected)

The FUNCTION menu gives you the option of setting the following 
functions:
 

•   ROLLER SHUTTER/BLIND (select either shutter or blind)

•  RUNNING TIME

•  EXPERT MODE

•  INITIAL OPERATION (for service purposes)

EXPERT MODE
If selecting the city (EXPERT MODE OFF) is not precise enough, 
you can make a fine adjustment by setting the degrees of longitude 
and latitude (EXPERT MODE ON).

Warnhinweise

Programming radio channel settings

EN | 19

PRIORITY 

(factory setting priority = OFF, 

only visible in expert 

mode

)

If the priority is switched to “ON“, the clock has a higher priority and 
overrides the manual-automatic sliding switch setting of the hand-held 
transmitter programmed in the receiver.

Clock commands are executed even if the manual-automatic sliding 
switch of the hand-held transmitter programmed in the receiver is set 
to “



“.

If the manual-automatic clock sliding switch is set to “



“, no clock 

commands will be executed.

If the priority is “OFF”, clock commands are only executed when the 
manual-automatic sliding switch of the hand-held transmitter pro-
grammed in the receiver is set to “



”.

SHADING 

(factory setting shading = OFF

, only 

visible in expert mode

)

If shading is switched to “ON“ the automatic shading system is 
switched off with the “



“ clock command.

The automatic shading system is switched on by the „



“ clock

command.

PREREQUISITE!
The manual-automatic selection switch of the programmed
transmitter has to be set to „



“.

As long as the manual-automatic sliding switch of the programmed 
transmitter is set to “



“ , the automatic shading is always switched off 

and is not affected by the timer.
If shading is switched to “OFF“, then the automatic shading system is 
not influenced by the clock.