22 | EN
EN | 23
The AstroTec-868 bidi (item No 28 320.0006) is a radio wall trans-
mitter for
exclusive use with bi-directional receivers
(use of
the AstroTec-868 bidi with unidirectional transmitters and receiv-
ers is not possible, in this case please use the previous model
AstroTec-868 (item No 28 320.0001) resp. AstroTec-915 (item No
28 320.0906).
Teach-in /deletion of the radio transmitter
As long as the AstroTec-868 bidi/-915 bidi has not been prepared
for the teach-in on at least one receiver, an acoustic signal sounds
each time a key is activated in order to inform about the omitted
teach-in.
Transmitter teach-in
Requirement: The drive must be installed
For bi-directional receivers already installed electrically, please
switch the safety control off and switch it on again after a few
seconds. The drive is now ready for the teach-in for a period of
approx. 5 minutes.
Stand directly in front of the hanging with the AstroTec-868 bidi/-
915 bidi.
Press the teach-in button
P
on the rear side of the device. The
hanging moves up and down independently for approx. 2 minutes.
To define key allocation, please press the
UP
button (maximum 1
second) on the AstroTec-868 bidi (front-side of the device) directly
after an upward movement and the status of bi-directional teach-in
is signaled acoustically.
The roller shutter stops briefly and then continues its movement.
Please press the
DOWN
button on the AstroTec-868 bidi/-915 bidi
directly
after the start of a downward movement and the status of
the bi-directional teach-in is signaled acoustically.
The roller shutter stops.
The AstroTec-868 bidi/-915 bidi teach-in is now completed.
Teach-in for further transmitters
If you want to teach-in further transmitters on the receiver, you
may proceed as follows:
Press the
UP
-
DOWN
and teach-in
P
button on the already pro-
grammed transmitter until the LED extinguishes.
Press the teach-in button
P
on the rear side of the device briefly.
The hanging moves up and down independently for approx. 2
minutes.
To define the key allocation, please press the
UP
button (maxi-
mum 1 second) on the AstroTec-868 bidi (front-side of the device)
directly after the upward movement and the status of bi-directional
teach-in is signaled acoustically.
The roller shutter stops briefly and then continues its movement.
Please press the
DOWN
button on the AstroTec-868 bidi directly
after the start of a downward movement and the status of the bi-
directional teach-in is signaled acoustically.
The roller shutter stops.
The AstroTec-868 bidi/-915 bidi teach-in is now completed.
AstroTec-868 bidi
AstroTec-868 bidi
Summary of Contents for AstroTec-868 bidi
Page 24: ...46 EN EN 47...
