elero AstroTec-868 bidi, Operating Instructions Manual

Program other AstroTec-868 bidi transmitters

Delete AstroTec-868 bidi transmitters

Programming further transmitters

If you wish to program other transmitters to the receiver you can 
proceed as follows:
1. 

On a transmitter, which has already been programmed to the 
receiver, press the 

UP

, 

DOWN 

and the programming button 

P 

until the LED goes out.

2. 

Press the programming button 

P 

on the back of the device briefly.

The shutter will automatically begin to move up and down for 
approx 2 minutes.

3. 

In order to define the keyboard layout, press the 

UP

 button (front 

of the device) on the AstroTec-868 bidi/-915 bidi 

immediately 

(max. 1 second) after beginning upward motion; the status of the 
bidirectional programming is acoustically signalised.
The roller shutter stops briefly and then continues to travel again.
Press the 

DOWN

 button on the AstroTec-868 bidi/-915 bidi 

immediately 

after beginning downward travel; the status of bidi-

rectional programming is acoustically signalised.
The roller shutter stops.
The AstroTec-868 bidi/-915 bidi i

s now programmed. 

Deletion of individual transmitter

1. 

Simultaneously 

press programming button 

P 

(rear of the device) 

and the 

STOP

 button (front of the device) 

2. 

Keep this button combination pressed until the LED goes out 
briefly for a second time (approx. 6 seconds) 

Deletion of all transmitters

1. 

Simultaneously press the 

programming button P 

(rear of the 

device) and buttons 

UP 

and 

DOWN 

and 

STOP

 (front of the 

device) 

2. 

Keep this button combination pressed until the LED goes out 
briefly for a second time (approx. 6 seconds) 

Warnhinweise

Programming

Main menu (Overview of the menu)

1. Press the MENU button until TIME/DATE appears.
2. To select further menus, press the +/- buttons.
3. Press the MENU button to switch to operating mode.

/-

+

+

Operating mode

FUNCTION

SETTING

PROGRAMM

TIME/DATE

PROG1

PROG2

+/–

+/–

+/–

+/–

MENU

TIME/DATE (to set the time and date)

1.  Press the MENU button until TIME/DATE appears.
2.  By pressing OK, you get to the TIME menu level.
3.  Now set the current time using the +/- buttons.
4.  If the time is set correctly, confirm by pressing OK.
5.   Repeat the above procedure for the settings YEAR, MONTH 

and DAY. TIME/DATE appears.

6.   Press the MENU button to switch to operating mode.

K

O

O K

/-

TIME/DATE

TIME

YEAR

MONTH

DAY

TIME/DATE

OK

OK

OK

OK

OK

+/–

+/–

+/–

+/–

26 | EN 

EN | 27